PDA

View Full Version : 101, 110 but no 119?...help!


LordSnark
September 4th, 2002, 08:48 PM
Ok I just put up my new Terk triple LNB dish. Everything is going good no problem with anything except when we get to getting a single from the 119 sat. I get a 92 on the 101, and I get like a 88 or something near there from the 110 sat, but when it tries to find a 119 single there is nothing. I have checked and rechecked my tilt, rotation, and angle setting and checked them again. I have swong my dish all over hell and back but still no 119 single. Is there a trick to this. Is there something special I have to do, or could it be that the multi switch that came with it is bad. This is my setup, it is a Terk dish and the multi switch is built into where the three LNb's plug into it has 4 cables that run out of it that you can plug your recivers into...I have also connected my reciever to all 4 just to make sure it wasnt something bad with that, but it didnt help. PLease any imput would be helpfull, I am so close yet so far away.:Z

smack
September 4th, 2002, 10:32 PM
First, make sure your mount is perfectly plumb & level ...it's critical.

Second, I've kown acouple folks with the integrated MS that have had problems with the 119 .... both were declared bad by the mfr and RMA (returned for new unit).

Check the mount, then call the vendor.


Good Luck

Scott

LordSnark
September 4th, 2002, 10:54 PM
The mount looks good I will contact Terk and see what they have to say about it. Thanks for the feedback.