krypto and hughes e86?

[MOS90]

has anyone used this ird for emulation with krypto. any luck?

[crzywhtboy]

I know it works with the hu gold...haven't had a need for the krypto...

Good luck!


crzy

[subz]

Kyrpto works fine with the E86. I am currently using one.

[MOS90]

subz, what krypto setting did you have the best luck with.

[subz]

I set everything to 0. I am running a 1ghz PIII.

[MOS90]

subz could you be more specific on options. ive tried it all not working

[subz]

I can't get more specific about the Krypto settings. I installed Kypto, And I moved the slider bar to 0. That is all I did. If you are running less than a 1ghz PC, you will probably have mess around with the slider till you keep a picture and don't IVAC. Start at 0 and work your way up. Restart Krpto everytime you change the number. I found it better to actually save the setting and exit the software completly then reload it. Also in the E86 you must remove your EMU board a little bit so it says insert valid access card, then start Krpto, then slide the EMU board in. The hard reset did not work for me, but that did. Good luck.

-SuBz

[MOS90]

so you slide the emu board in until ivac, then slide it back start krypto, then slide back in.or did you slide emu board in until ivac, start krypto, then slide emu board out then back in.

[subz]

You slide the emu board in after starting Krypto. If you get an IVAC you need to change your settings and save them. You then exit Krypto. Pull the emu board out and start the process again.