check switch problems with dp34 switch

[mogack]

I am setting up a superdish trying to find sat 105, everytime I run check switch it says port one is not corrected properly. I am 99% sure everything is connected properly, I even changed some compression fittings to make sure they were good. Can someone tell me what I am doing wrong??? Thanks,

[RiseStar]

Are you using an all dishpro system (LNBF, Switches, Receiver)? The problem you describe can occur if you are trying to mix a legacy component with a dishpro component, which are not compatible without an adapter. Failing that, you may have a faulty switch, are all the other ports working correctly on the switch?

[mogack]

all other ports are working, i have a 322 dishpro reciever. and a super dish. i am hooked up to 3 sat in ports with 110 119 105 lnb's I need 105 and superdish for locals. it keeps telling me , port one is not connected when i go to the details of the check switch.


Are you using an all dishpro system (LNBF, Switches, Receiver)? The problem you describe can occur if you are trying to mix a legacy component with a dishpro component, which are not compatible without an adapter. Failing that, you may have a faulty switch, are all the other ports working correctly on the switch?

[ebms1]

all other ports are working, i have a 322 dishpro reciever. and a super dish. i am hooked up to 3 sat in ports with 110 119 105 lnb's I need 105 and superdish for locals. it keeps telling me , port one is not connected when i go to the details of the check switch.



switch your 3 ports & see if you problem port moves