shjaffri
August 6th, 2007, 06:03 PM
Please help I am having trouble setting up my VS ultra, I am following the setup guide, but I cannot see the channels, just getting message searching for signal for all channels....
In viewsat ultra setup I select universal LNB type for for two Dish 500's, installed with dp34 or dp44 switch for three TV's.
I selected echo star 110, 119, and 61.5 for satellite type
Ok here is my original DN setup.
I have one DN dual tuner receiver setup for two TV's. For the 3rd TV I am replacing DN receiver with VS ultra. My original installation is from DN, so I am not replacing the switch as it is already at hard to reach area, and I still paying DN at monthly basis, and I am not installing 3rd party software, and using the factory software. I don't know the TP freq for my switch so left the default. Now not sure if it is due to TP freq, if it is please suggest the best TP freq for DP34 or DP44 switch type.
Any step by step help would be much appreciated.
Regards
Edit/Delete Message
In viewsat ultra setup I select universal LNB type for for two Dish 500's, installed with dp34 or dp44 switch for three TV's.
I selected echo star 110, 119, and 61.5 for satellite type
Ok here is my original DN setup.
I have one DN dual tuner receiver setup for two TV's. For the 3rd TV I am replacing DN receiver with VS ultra. My original installation is from DN, so I am not replacing the switch as it is already at hard to reach area, and I still paying DN at monthly basis, and I am not installing 3rd party software, and using the factory software. I don't know the TP freq for my switch so left the default. Now not sure if it is due to TP freq, if it is please suggest the best TP freq for DP34 or DP44 switch type.
Any step by step help would be much appreciated.
Regards
Edit/Delete Message