Dish help

[forevergreat]

I am currently reading 110 but there are some stations ie: TBS which I cannot see...would the balance of stations be on the 119?

[jpipes]

Run a Check Switch test from the Point Dish screen. If it passes this test it will confirm that you can see all the odd- and even-numbered transponders. If it fails it will show you which transponders are missing. This may be a switch problem or possibly an LNB problem if the switch is built-in to the LNB

If it passes the Check Switch, next go to the System Info screen. (Menu 6,1,3) This will show you the status of your system, including if all satellites are being seen.

If the system reads "Good" after its self-test, look to see if you can watch your missing channels now. If they are still missing, try a front panel reset...(Push and hold down the power button on the front of your receiver for 10 seconds. This will cause your receiver to re-boot. You will need to wait as signal aquisition is re-aquired, don't panic, the receiver is just going thru its re-boot.)

If after all this you still miss some stations, you may need to consult DISH or have a tech come out to determine if it is a bad equipment issue.

Good Luck!

[cshsrh]

You can also press menu 6, 1, 3 to enter the system info screen and there you can with assistance from dish verify your software version also. But a good check switch (menu 6,1,1) can tell you alot about what's going on. More than likely it's a alignment issue!