The clock is off

[shitstorm]

I did an installation for a friend using a B-50 unit w/ a 2nd generation dish. Signal and everything is fine. However, when I call up the guide function, it shows everything in midwest time when I'm out here on the west coast. Basically, the clock is 2 hrs. ahead. Now here's the other part, when you set the timer to record it functions properly. It's an annoyance more than anything and I know that the receiver gets its time from the satellite based on your location. So I don't know what's wrong or how I can fix it. Any help would be greatly appreciated. I'm stumped.

[gunsmoke2]

Is it a sub from DTV.? If so you should be able to call them and have them correct it over the air.

[shitstorm]

Unfortunately, it's not a sub. So I need outside help to find a solution to the problem. Thanks.

[Desert007]

What software is on the card. If T3 then change your spending limit to 001 or 002.

Desert007

[shitstorm]

I'm not sure because it was done by another friend but I know that it's either a JSP or a Magic at eng. mode. Those are the only two he uses. Thanks again for any help.