Echostar 61.5

[cdnwby]

Hi there,
I have just installed 2 DNet echostart dish's one at 119 the other at 61.5. The 119 degrees worked fine, however when I hooked the 61.5 up with the multi-dish switch, it does not show a signal. Its as if the dish was not there.

Does anyone have any ideas as to why this is happening. Any help would be much appreciated.

[Bestech]

Did you hook it up directly to the ird and point it seperatly before you hooked it up to the switch? I would recommend doing this first and selecting the 61.5 in the mult dish pointing menu. After you have a good signal, then hook up the switch and run a switch test. It should then show up, if it doesn't, or the switch doesn't pass the test, you have a bad switch. Hope this helps.:cool: