Oval not switching between sats?? Help Pls

[biglips31]

Currenty have been using H card with bootstrap using
in a RCA dtc-100 HDTV receiver. Was using with Round 18"
dish and everything was fine.

Just recently installed oval in place of round to receive
HDTV. Install was easy. Had problems though receiving from
110 sat. Seemed like either IRD or 22khz switch was not going
back to 110 sat all the time.. Anyhow, finally got 110 set at
80 signal and 119 was about the same.

I will watch a hdtv channel and then go back to a channel off
the 110 sat and it will say searching for sat?? What gives??
Ird or Switch?? Any Ideas??

I went into menu and set at round 18 and works. Then I go into
oval two lnbs and hdtv works but intermittanly will not find
sat.. very erractic.

Thanks for any help...

[PERUCHO]

are you sure you are in the right bird dave works out of 101 and 119 not 110 that is for charlie
what kind of switch you have the 4x2 or the 4x4 if it is the 4x2 you are going to need to cross your wires like a and b to one side this are the wires that come out of the lnbs if you have the 4x4 then it goes a and a on one side and b and b to the other one
make sure you are in the right bird first good luck

[step1]

When you set for 2 LNBs it`s for 101 and 119. If you want 110 DTV try settting to 3 LNBs